To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including brush inspection and replacement) should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts. Never use solvents to clean saw or guard components. Never let any liquid get inside the tool never immerse any part of the tool into a liquid. Use only mild soap and damp cloth to clean the tool. If you need assistance in locating any accessory, please contact D
Portable Saw Stand Outfeed Side Support Replacement Throat Plate Dado Throat PlateĪccessory may be hazardous. WALT manufactures the following accessories for your Recommended accessories for use with your tool are available at extra cost from your distributor or local service center. Threads on the underside of your saw with general purpose grease, shown in Figure 25. b) Turn the saw on its side, so the bottom, open part ofĬ) Clean and lubricate the height adjustment screws If you have difficulty raising or lowering the blade:Ī) Unplug the saw.
The height adjustment screw may require periodicĬleaning and lubrication. All motor bearings are permanently lubricated at theįactory and no additional lubrication is needed.Ģ. When cutting wet wood without a vacuum or when cutting with a dado blade, removing the dust access door may be helpful in preventing clogs.ġ. Clean out the excess dust, and re-secure the access door with the hair pin cotters. To clear the dust collection system:ī) Turn the saw on its side, so the bottom, open part ofĬ) Open the dust access door shown in Figure 24 by After extended use, the saw’s dust collection system may become clogged. If the saw is used on a table or other surface without an opening on the bottom, clean out the base and accumulated saw dust after each cut. However, some dust will fall inside the base. If the saw is operated without a vacuum attached, most of the dust will be blown out the dust collection port. For best results, connect a vacuum to the port at the rear of the saw. Your table saw is equipped with a dust shroud and dust collection port. Be sure to place the guard and standard throat plate back in position and check adjustments when the dado cuts are complete. DO NOT USE WIDER COMBINATIONS.ĬAUTION: Always check dado blade clearance before Maximum dado width on this saw is 13/16" (20mm). use several successive passes rather than attempting to make it with one pass. Use EXTREME care when using the dado without the guard. When using the dado, the guard must be removed. A dado cut is commonly used to add support and line up a shelf for a cabinet, bookcase or some such project.
Anytime a cut is required that is considerably wider than the saw kerf, a dado is used. When using the dado, the special dado insert (also sold as an accessory) must be used.
0 kommentar(er)
